Fisher Price 6 VOLT QUICK CHARGER H7456 User Manual

H7456, J1717  
Product features may vary from the picture above.  
IMPORTANT SAFETY INSTRUCTIONS  
SAVE THESE INSTRUCTIONS.  
-
®
For use with a single Power Wheels  
6-volt lead acid battery only.  
This product is not intended for children; it is for adult use only.  
This charger is not a toy.  
Please read this booklet before first-time use. Keep these instructions  
for future reference, as they contain important information.  
IMPORTANT INFORMATION  
IMPORTANT! A battery can be severly damaged if it is not charged  
after each use. For maximum battery life, charge the battery 100%  
(solid green) every other charge.  
If your battery is new, charge the battery 100% (solid green).  
Do not charge the battery longer than 30 hours.  
Adults Note: Regularly examine the charger for damage to the cord,  
plug, housing or other parts that may result in the risk of fire, electric  
shock or injury. In the event of any damage, do not use the charger  
until the damage has been properly repaired. Please call  
1-800-348-0751.  
Before charging the battery, examine the battery case for cracks and  
other damage which may cause sulfuric acid (electrolyte) to leak during  
the charging process. If damage is detected, do not charge the battery  
or use it in your vehicle. Battery acid is very corrosive and can cause  
severe damage to the surfaces it contacts.  
Do not charge the battery on a surface (such as a kitchen counter top)  
which could be damaged by the acid contained inside the battery. Take  
precautions to protect the surface on which you charge the battery.  
Do not short circuit the battery.  
The battery must be upright while charging.  
Disconnect the charger before cleaning.  
Charger specifications are as follows:  
Input 100-240V AC 50/60Hz 28W  
Output 6V DC 2.5A  
3
IMPORTANT INFORMATION  
WARNING  
PREVENT FIRE  
- Use of the wrong type battery or charger  
could cause a fire or explosion resulting in  
serious injury.  
- Use of Power Wheels® components in  
products other than Power Wheels® vehicles  
could cause overheating, fire or explosion.  
• The battery must be handled by adults only.  
The battery is heavy and contains sulfuric  
acid (electrolyte). Dropping the battery could  
result in serious injury.  
• Never allow children to charge the battery.  
Battery charging must be done by adults only.  
A child could be injured by the electricity  
involved in charging the battery.  
• Read the safety instructions on the battery.  
• Examine the battery, charger and their  
connectors for excessive wear or damage  
each time you charge the battery. If damage  
or excessive wear is detected, do not use the  
charger or the battery until you have replaced  
the worn or damaged part.  
4
CHARGING INSTRUCTIONS  
Approximate  
Status  
Charge  
Time  
--  
Solid Red  
Charging  
Flashing Green  
Solid Green  
Flashing Red  
Ready for Use  
2 hours  
6-8 hours  
--  
100% (Full)  
*
No Charge  
**  
For maximum battery life, charge battery 100% (solid green) every  
other charge.  
*
Error - wrong or dead battery.  
**  
5
CUSTOMER SERVICE  
If you have any questions about this product, please call our toll-free  
service lines at 1-800-348-0751 from 9 AM to 7 PM (EST) Monday  
through Friday, and 11 AM to 5 PM (EST) Saturday. You can also visit  
us on-line at www.powerwheels.com.  
®
For your convenience, Power Wheels maintains an independently  
owned and operated Authorized Service Center Network with more  
than 300 authorized service centers nationwide. The authorized service  
centers will repair or replace parts under warranty at no extra charge,  
and can perform non-warranty repairs for a minimal charge. To find the  
authorized service center nearest to you, visit us on-line at  
www.powerwheels.com or call 1-800-348-0751.  
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052 U.S.A.  
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.  
PRINTED IN CHINA  
H7456c-0920  
6
QUICK CHARGE  
Charger  
Wall Outlet  
Power Cord  
Power Cord  
Charger Connector  
6 Volt Battery  
Connector  
Plug the power cord into the charger.  
Plug the charger connector into the 6-volt battery connector.  
Plug the power cord into a standard 120 volt wall outlet.  
To connect to a supply that is not in the United States, use an adapter  
(not included and sold separately) with the proper configuration for the  
power outlet.  
Note: The charger may be hot to the touch while charging. New batteries  
may make a “sizzling” or “bubbling” noise and swell slightly. These are  
normal conditions and do not indicate a problem.  
Charge the battery 100% (solid green) or Ready for Use (flashing  
green). For maximum battery life, charge battery 100% (solid green)  
every other charge.  
Unplug the charger from the wall outlet when not in use.  
7
PROBLEMS AND SOLUTIONS  
Problem  
Possible Cause  
Solution  
No status light  
No power  
to charger  
Make sure power flow to the wall outlet  
is “ON.  
Loose connections Check connections of all plugs. Make sure  
the charger connector is tightly plugged  
into the battery connector and the power  
cord connector is tightly plugged into both  
the charger and the wall outlet.  
Bad charger  
There is no sure way to tell if your charger  
is working unless you have a volt meter.  
If you suspect there is a problem with  
your charger, contact Power Wheels®  
Consumer Relations.  
Wrong battery  
This charger is intended for use only  
with a Power Wheels® 6-volt lead  
acid battery.  
Flashing red  
status light  
Loose connections Check connection of all plugs. Make sure  
the charger connector is tightly plugged  
into the battery connector and the power  
cord connector is tightly plugged into both  
the charger and the wall outlet.  
Undercharged  
battery  
Battery needs a 100% (solid green)  
charge every other use.  
Battery dead  
Replace battery with a new,  
Power Wheels® 6-volt lead acid battery.  
Solid red  
status light  
Undercharged  
battery  
Charge battery 100% (solid green) or  
Ready for Use (flashing green).  
8
PROBLEMS AND SOLUTIONS  
Problem  
Possible Cause  
Solution  
Battery is warm  
while charging  
Normal while  
quick charging  
No action required.  
Charger is hot  
while charging  
Normal while  
quick charging  
No action required.  
Short vehicle run Undercharged  
time or vehicle  
runs sluggishly  
Charge battery 100% (solid green)  
or Ready for Use (flashing green).  
battery  
Flashing green  
status light -  
but vehicle does  
not run  
Battery dead  
In rare situations, a severely depleted  
(dead) battery will give a false, Ready  
for Use (flashing green) status.  
Try charging the battery again for 6-8  
hours. If your vehicle still won’t run,  
you will need to replace your battery  
with a new, Power Wheels® 6-volt  
lead acid battery.  
Solid green  
status light -  
but vehicle  
does not run  
Battery dead  
In rare situations, a severely depleted  
(dead) battery will give a false, 100%  
(solid green) status. Try charging the  
battery for a full 6-8 hours. If your  
vehicle still won’t run, you will need  
to replace your battery with a new,  
Power Wheels® 6-volt lead acid battery.  
Flashing green  
status light does  
not progress to  
a solid green  
status light  
after 6-8 hours  
of charging  
Battery may  
be dead  
Unplug the charger from the battery and  
wall outlet for at least 12 hours. Now,  
charge the battery again for 6-8 hours.  
If the status flashes red or you get the  
same results, replace the battery with  
a new, 6-volt lead acid battery.  
and vehicle  
does not run  
9
FCC STATEMENT  
(United States Only)  
This equipment has been tested and found to comply with the limits for  
a Class B digital device, pursuant to part 15 of the FCC rules. These  
limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses  
and can radiate radio frequency energy and, if not installed and used  
in accordance with the instructions, may cause harmful interference to  
radio communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause  
harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged  
to try to correct the interference by one or more of the following  
measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
Note: Changes or modifications not expressly approved by the  
manufacturer responsible for compliance could void the user's authority  
to operate the equipment.  
Operation is subject to the following two conditions: (1) this device  
may not cause harmful interference and (2) this device must accept any  
interference received, including interference that may cause undesired  
operation.  
10  

AB Soft XS 25000 User Manual
Briggs Stratton 12V800 User Manual
Brother FAX 1170 User Manual
Canon MultiPASSTM C50 User Manual
Cecilware Liquid Iced Tea Dispenser TT2 User Manual
Danby dac12077ee User Manual
Fisher Price 71592 User Manual
Heat Controller Inc Air Conditioner HMG__F1E User Manual
Heat Controller Inc Air Conditioner HMG__X1E User Manual
HoMedics Adjustable Height Lumbar Massager LLUV 200 User Manual